York RecipPak YEAZ88DR6 - Optional Decorative Tamperproof Enclosure (Louvered); General; Installation

FORM 150.60-NM4
YORK INTERNATIONAL 85
FIG. 39  LOUVERED INSTALLATION
LD02103
OPTIONAL DECORATIVE TAMPERPROOF
ENCLOSURE (LOUVERED)
General
A louvered tamperproof enclosure is available for the
chiller for the prime purpose of deterring unauthorized
access to components of the chiller.
Kit 475-04561-502 is the decorative/tamperproof enclo-
sure which consists entirely of louvered sheet metal pan-
els along with mounting hardware. This kit has a further
purpose of presenting a pleasing appearance to the chiller
when it is located in a highly visible area.
Installation
1. Refer to Fig. 38 and the associated parts list. Before
starting installation, all of the items in the kit should
be identified by comparing with Fig. 39.
2. All holes for mounting kit parts are provided in both
the chiller frame and the added supports; therefore,
it should be unnecessary to drill holes.
3. Install the louvered panels using the proper hard-
ware and supports. Refer to Fig. 38 and the Parts
List for placement of the panels and the proper hard-
ware required. Discard existing grilles to attach the
louvered panels where necessary.
4. Notch panels to suit water connections and wiring
harnesses as needed.
5. If the High Ambient Sunshield Kit or Disconnect Op-
tion is installed, field adaption will be required where
parts of the kits interfere. Touch up exposed metal
parts to prevent rust.
FIG. 38  COMPLETE INSTALLATION
(Typical Installation Shown)
25246A
ASSEMBLY INSTRUCTIONS
1. Condensing and remote DX evaporator arrangement shown
2. Standard units (with cooler) discard items 20 & 21.
3. Kit will contain extra parts to be used on 3 compressor chillers.
Extra parts should be discarded
Parts List
PART # ITEM QUAN. DESCRIPTION
075-02563-001 1 2 Panel, Louvers Side Btm.
075-02563-002 2 4 Panel, Louvers Side Top
075-02563-016 3 1 Panel, Louvers Front Top L.H.
075-02563-015 4 1 Panel, Louvers Front Top R.H.
075-02563-005 5 2 Panel, Louvers Rear Top
075-02563-006 6 2 Panel, Louvers Rear Btm.
075-02563-025 7 1 Support, Front Ctr.
075-02563-028 8 1 Support, Front R.H.
075-02563-026 9 1 Panel, Louvers Front Btm. R.H.
075-02563-027 10 1 Panel, Louvers Front Btm L.H.
075-02563-011 11 1 Panel, Louvers Side Btm. L.H. F.R.
075-02563-012 12 1 Panel, Louvers Side Btm. L.H. R.R.
075-02501-000 13 12 Bracket
075-02502-000 14 12 Clip, Retainer
075-02503-000 15 2 Clip, Retainer
075-02563-022 16 1 Support, Front L.H.
075-02563-023 17 1 Support, Top L.H.
075-02563-024 18 1 Support, Top R.H.
075-02563-017 19 1 Panel, Louvers Front Top
021-16205-000 51 40 Screw, Cap Hex 3/8-16 x 1-1/2
021-16158-000 52 40 Lock Washer Spg. 1/4
021-16139-000 53 40 Net, Hex 3/8
021-16163-000 54 141 Screw, Tap Cut 1/4 x 1/2
021-16161-000 55 11 Screw, Cap Hex 1/4-20 x 3/4
021-16210-000 56 11 Lock Washer Spg. 1/4
021-16151-000 57 11 Nut, Hex 1/4
021-17223-000 58 2 Screw, Cap Hex 1/2-13 x 1
021-16157-000 59 2 Lock Washer Spg. 1/2
021-16155-000 60 2 Nut, Hex 1/2