START-UP
RECORD DATA
POWER SUPPLY:
_________/ _________ / __________
DATA
MOTOR
Nameplate Volts ____________ Amps _______________ Volts _______________ Amps ____________
Run Amps ___________ / ____________/ __________ ___________ / ___________ / ___________
Catalog Number _____________________________________ ______________________________________
Spec Number _____________________________________ ______________________________________
_____________________________________ ______________________________________
RPM Nameplate __________ Actual____________ Nameplate __________ Actual ____________
Frame size _____________________________________ ______________________________________
Service Factor
_________________________________ _________________________________
Jump (Skip) Frequencies ___________ / ____________/ __________ ___________ / ___________ / ___________
B
elts (Qty & ID #) _____________________________________ ______________________________________
Belt Tension Tag________________ Actual ____________ Tag________________ Actual _____________
Fan RPM (DN) Tag________________ Actual ____________ Tag________________ Actual _____________
OTHER UTILITIES
Potable Water Pressure _____PSI, Pneumatic Air Pressure _____PSI
Manufacture Name _____________________________________ ______________________________________
Type or Model Number _____________________________________ ______________________________________
Code or Shop Order Number _____________________________________
Serial Number _____________________________________ ______________________________________
PERFORM THE FOLLOWING STEPS IN ORDER:
Refer to safety standards. Ensure all door latches are secured before starting.
□
1. With all Electric Power off, all disconnect switches open and
fuses removed, check each circuit with an Ohm meter to
ground observing no continuity. Reinstall fuses.
rotation.
all dampers closed.
Fan INSPECTION
□
Check bearings and locking collars for properly tightened
setscrews, bolts and nuts.
□
Fan wheel properly aligned, tight on shaft and freely
moving.
□
Sheaves properly aligned and tight on shaft.
□
Check fan base isolators and thrust restraints for proper
adjustment. Note: Do not remove functional bolts
from seismic isolators.
□
Belt tension adjusted properly per drive pkg. label on fan.
□
Check fan alignment with unit discharge. Adjust with
isolation.
□
Fan bearings have been re-lubricated properly.
To Next Page
Loading...
