York XT AHU - Page 114

JOHNSON CONTROLS
114
FORM 102.20-OM2
ISSUE DATE: 6/01/2015
APPENDIX B – LONG-TERM STORAGE
FORM 50.20-CL3 (909)
JOHNSON CONTROLS
2
1.0 Monthly
Rotate
Shafts
5 PSI Coil
Pressure
Motor Belts &
Drives Protected
and Dry
Comments
Date
Initial
Date
Initial
Date
Initial
Date
Initial
Date
Initial
Date
Initial
Date
Initial
Date
Initial
Date
Initial
Date
Initial
Date
Initial
Date
Initial
2.0 Quarterly Checks
2.1 Complete Assembly - The unit should be checked quarterly to see that no damage has occurred to the
protective covering. Any apparent damage to the covering or units should be noted in the comments
section of the quarterly log sheet (see page 3 of this document).
2.2 Grease bearings every three months. The greasing procedure is explained in the product service
manual.
3.0 Semi Annual Checks
3.1 None
4.0 Annual Checks
4.1 Unwrap all electrical cabinets and install new Vapor Emitters (YORK P/N 026-37705-000); reseal.
4.2 Re-spray all exposed shafts and sheaves with anti-corrosion spray, YORK P/N 026-37707-007.