JOHNSON CONTROLS
165
SECTION 10 – MAINTENANCE
Form 150.63-NM9
Issue date: 5/20/2021
10
Table 35 - BACnet and Modbus Communications Data Map (cont’d)
Sys 1 Condenser Fan Stage
Sys 2 Condenser Fan Stage
43
AI33 546 03,04 x1 ADF 40 None None
Unit Control Mode [1=LW, 2=RW, 3=DA, 4=SP, 5=HC,
SSS
Anti-Recycle Time Programmed
Leaving Chilled Liquid Temp Cutout
Low Ambient Temperature Cutout
Low Suction Pressure Cutout Heating (HP)
Low Suction Pressure Cutout Cooling
High Discharge Pressure Cutout
Sys 1 Cooling Setpoint (SP Unit)
Sys 1 Cooling Range (SP Unit)
Sys 2 Cooling Setpoint (SP Unit)
Sys 2 Cooling Range (SP Unit)
Sys 1 Discharge Temperature (EEV)
Sys 1 Discharge Superheat (EEV)
Sys 2 Discharge Temperature (EEV)
Sys 2 Discharge Superheat (EEV)
Leaving Liquid Hot Temp (R-410a/R-454B)
Return Liquid Hot Temp (R-410a/R-454B)
Remote Setpoint 1 (SP Unit)
Remote Setpoint 2 (SP Unit)
03,04 x10 ADF 64 °F °C Remote Heating Setpoint (HP) OOO
Sys 1 Alarm [0=No Alarm, 1=Alarm]
Sys 2 Alarm [0=No Alarm, 1=Alarm]
Sys 1 Liquid Line Solenoid Valve
Sys 1 Mode Solenoid Valve (HP)
Sys 1 Hot Gas Bypass Valve
77
S1_BHS
BI10 1291 01,02,03 N/A BD13 0/1 0/1
Bivalent Heat Step (YLAE HP)
Compressor Heater (R-410a/R-454B chillers, YCWL
OOO
Sys 2 Liquid Line Solenoid Valve
Sys 2 Mode Solenoid Valve (HP)
Lead System [0=Sys 1, 1=Sys 2]
BI16 1297 01,02,03 N/A BD19 0/1 0/1 Sys 1 Comp 3 Run SSS
BINARY READ ONLY POINTS
Ref
Num
BACnet Name
Object
Instance
Modbus
Address
Modbus Data Type
Supported
Modbus
Scaling
(See Note 5)
N2 Metasys
Engineering Units Point List Code: S = Standard O = Optional N = Not Available
Property of Johnson Controls, Inc.
Subject to change without notice.
2 of 4
02/11/2020