FORM 150.75-NM2
93
YORK INTERNATIONAL
OPTIONAL DECORATIVE TAMPERPROOF
ENLCOSURE (LOUVERED & WIRE GRILLE)
General
A combination louvered and wire grilled enclosure is
available for the chiller for the prime purpose of detering
unauthorized access to components of the chiller.
Kit 475-04518-002 is the decorative / tamperproof en-
closure which consists of a combination of louvered
sheet metal panels and weather resistant wire grilles
along with mounting hardware. This kit has a further
purpose of presenting a pleasing appearance to the
chiller when it is located in a highly visible area. Two
kits must be installed to complete the installation.
Installation
1. Before starting installation, all of the items in the kit
should be identified by comparing with Fig. 45.
2. All holes for mounting kit parts are provided in both
the chiller frame and the added supports; therefore,
it should be unnecessary to drill holes.
3. Installed the louvered panels and wire grilles using
the proper hardware and supports. Refer to Fig. 45
and the Parts List for placement of the grilles / pan-
els and the proper hardware required. Discard ex-
isting grilles to attach the louvered panels where
necessary.
FIG. 45 LOUVER AND GRILLE INSTALLATION FOR EACH KIT
4. Notch grilles to suit water connection and wiring har-
nesses as needed.
5. If the High Ambient Sunshield Kit or Disconnect Op-
tion is installed, field adaption will be required where
parts of the kits interfere. Touch up exposed metal
parts to prevent rust.
LD01954
Parts List For Each Kit
PART # ITEM QTY DESCRIPTION
075-02563-002 1 8 PANEL, LOUVERS Side Top
075-02563-005 2 2 PANEL, LOUVERS Rear Top
075-02563-015 3 1 PANEL, LOUVERS Front Top R.H.
075-02563-016 4 1 PANEL, LOUVERS Front Top L.H.
075-02563-017 5 1 PANEL, LOUVERS Front Top
075-02501-000 6 5 BRACKET
075-02502-000 7 24 CLIP, Retainer
075-02503-000 8 4 CLIP, Retainer
026-31634-000 9 8 GRILLE, SIDE BTM.
026-32206-000 10 1 GRILLE, REAR BTM.
026-32207-000 11 1 GRILLE, FRONT BTM.
021-16205-000 51 44 SCREW, HEX 3/8-16 x 1-1/2
021-16158-000 52 44 LKWASHER SPG. 3/8
021-16139-000 53 44 NUT, HEX 3/8
021-16136-000 54 86 SCREW, TAP CUT 1/4 x 1/2
021-16161-000 55 6 SCREW, CAP HEX 1/4-20 x 3/4
021-16210-000 56 6 LKWASHER SPG. 1/4
021-16151-000 57 6 NUT, HEX 1/4
021-16203-000 58 81 SCREW, Tap Type F 1/4 x 3/4 LG.
021-16165-000 59 81 WASHER, FLAT 1.4
To Next Page
Loading...
