York YEHJZH009-24BAM1ABX - Page 13

11
Introduction for buttons on remote controller
LIGHT button
13
Press this button at unit On or Off status, Light On and Light Off can be set up.
After powered on, Light On is defaulted.
X-FAN button
14
Pressing X-FAN button in COOL or DRY mode, the icon is displayed and the
QUIET button
15
Press this button, the Quiet status is under the Auto Quiet mode (display " "
SLEEP button
16
Press this button, can select Sleep 1 ( ), Sleep 2 ( ), Sleep 3 ( ) and
cancel the Sleep, circulate between these, after electrified, Sleep Cancel is de-
faulted.
and "Auto" signal) and Quiet mode (display " " singal) and Quiet OFF (there
is no signal of " " displayed), after powered on, the Quiet OFF is defaulted.
Under the Quiet mode (Display " " signal).
indoor fan will continue operation for 2 minutes in order to dry the indoor unit even
though you have turned off the unit. After energization, X-FAN OFF is defaulted.
X-FAN is not available in AUTO, FAN or HEAT mode.
Sleep 1 is Sleep mode 1, in Cool, Dehumidify modes: sleep status after run for
one hour, the main unit setting temperature will increase 1Ƈ, 2 hours, setting te-
mperature increased 2Ƈ, the unit will run at this setting temperature; In Heat mode:
sleep status after run for one hour, the setting temperature will decrease 1Ƈ, 2
hours, setting temperature will decrease 2Ƈ, then the unit will run at this setting
temperature.
Sleep 2 is sleep mode 2, that is air conditioner will run according to the presetting
a group of sleep temperature curve.
In Cool mode:
(1) When setting the initial temperature 16Ƈ-23Ƈ, after turned on Sleep function,
(2) When setting the initial temperature 24Ƈ-27Ƈ, after turned on Sleep function,
(3) When setting the initial temperature 28Ƈ-29Ƈ, after turned on Sleep function,
the temperature will be increased 1Ƈ in every hour, after 3Ƈ the temperature
will be maintained, after 7hours, the temperature will be decreased 1Ƈ, after
that the unit will keep on running under this temperature;
the temperature will be increased 1Ƈ in every hour, after 2Ƈ the temperature
will be maintained, after 7hours, the temperature will be decreased 1Ƈ, after
that the unit will keep on running under this temperature;
the temperature will be increased 1Ƈ in every hour, after 1Ƈ the temperature
will be maintained, after 7hours, the temperature will be decreased 1Ƈ, after
that the unit will keep on running under this temperature;