14
Introduction for special function
About switch between Fahrenheit and Centigrade
Under status of unit off, press MODE and - buttons simultaneously to switch ć and .
Combination of "TEMP" and "CLOCK" buttons:
About Energy - saving Function
Press “TEMP” and “CLOCK” simultaneously in COOL mode to start energy-saving fun-
ction. Nixie tube on the remote controller displays “SE”. Repeat the operation to quit
the function.
About auto Quiet function
When quiet function is selected:
About Sleep function
Under the Fan and Auto mode, the Sleep function cannot be set up, under Dehumidify
mode, only Sleep 1 can be selected. Select and enter into any kind of Sleep mode, the
Quiet function will be attached and stared, different Quiet status could be optional and
turned off.
1. Under cooling mode: indoor fan operates at notch 4 speed. 10 minutes later or when
LQGRRUDPELHQWWHPSHUDWXUHćLQGRRUIDQZLOORSHUDWHDWQRWFKVSHHGRUTXLHW
mode according to the comparison between indoor ambinet temperature and set tem-
perature.
8QGHUKHDWLQJPRGHLQGRRUIDQRSHUDWHVDWQRWFKVSHHGRUquiet mode according
to the comparison between indoor ambient temperature and set temperature.
cooling, heating or fan mode.
8QGHUGU\IDQPRGHLQGRRUIDQRSHUDWHVDWTXLHWPRGH
4. Under auto mode: the indoor fan operates at the auto quiet mode according to actual
Combination of "TEMP" and "CLOCK" buttons:
About 8
ć
Heating Function
3UHVV³7(03´DQG³&/2&.´VLPXOWDQHRXVO\LQ+($7PRGHWRVWDUW
ć
Heating Function
Nixie tube on the remote controller displays “ ” and a seleFWHGWHPSHUDWXUHRI³ć”.
(46 if Fahrenheit is adopted). Repeat the operation to quit the function.
Note: If matching with smart zone controller for operation, the display on smart zone
controller will be maintained the original status.