9-10
Common Commands.
The commands below can be invoked in either Remote Control Mode or
in Result Reporting Mode, unless otherwise stated. Available commands are those in the Report
Database and Report System Information categories above.
When
Report Status (RY)
is invoked, the command obtains the 2700 status. The status
includes communications mode, sample result status, calibration result status, machine status
and remote command status. Below is a summary of responses and the interpretations.
Host to 2700: RY Report status of instrument
2700 to Host:
Communications mode R Result reporting mode
C Remote control mode
— Unknown
Sample status result U Results exist not sent to host
N No unsent results
Calibrate status result U Last cal not sent to host
N No unsent calibration results
Machine status I Idle in Run Mode
S Processing sample
C Processing calibration
A Processing autocalibration
M Processing manual sample
P Processing precal cycle
N Processing monitor cycle
T Processing postcal cycle
F Flushing and aborting error cycle
B Stabilizing baseline current
K Stabilizing calibration current
E Stabilizing motors
H Aborting Run Mode
R In Run Mode
Y In Standby Mode
D In Main Menu Mode
Remote command status I Idle, no pending command
S Sam command received. Pending
C Cal command received. Pending
— Unknown
An example status line may appear as follows:
CNUII
The information stated is that the 2700 is under remote control (C), no sample results are in
memory (N), calibration results remain unsent (U), the 2700 is idle in Run mode (I) and there
are no remote commands pending (I).
To Next Page
Loading...
