23
Figure 2-11
4. Connect the Multi-Channel Online Monitor sample tubing to the sample probe Luer connector (Figure 2-12).
Figure 2-12
5. Clamp the Pharmed
®
tubing approximately 1 inch (2.5 cm) above the luer connector.
6. If the vessel will be autoclaved, secure the polypropylene bag to the side of the vessel or headplate using autoclave
tape. Ensure that the Multi-Channel Online Monitor sample tubing is not pinched or crimped near the FISP connector.
Figure 2-13 shows the proper position of the sample tubing at the FISP connection.
Connector
To Next Page
Loading...
