Need help?Do you have a question about the YT Industries EMTB DECOY UNCAGED 10 and is the answer not in the manual?
General| Frame Material | Carbon |
|---|---|
| Fork Travel | 170 mm |
| Rear Shock | Fox Float X2 Factory |
| Rear Shock Travel | 165 mm |
| Motor | Shimano EP8 |
| Motor Torque | 85 Nm |
| Groupset | Shimano XTR |
| Drivetrain | 1x12 |
| Tires (Rear) | Maxxis Minion DHR II 27.5x2.8 |
| Stem | Renthal Apex 35 |
| Fork | Fox 38 Factory |
| Display | Shimano SC-EM800 |
| Brakes | Shimano XTR M9120 |
| Tires (Front) | Maxxis Assegai 29x2.5 |
| Saddle | SDG Bel-Air 3.0 |
| Seatpost | Fox Transfer Factory |
Initial steps for rear wheel assembly, including removing packing materials and axle.
Initial steps for front wheel assembly, including removing packing and axle.
Understanding sag, basic settings, and crucial safety warnings related to suspension.
Instructions on how to use the flip chip to adjust bike geometry for different riding conditions.
How to route cables correctly for the dropper seat post and other components.
Information on which batteries match E8000 and EP8 motors in Gen 1 systems.
Information on which batteries match EP801 and EP6 motors in Gen 2 systems.
Instructions for charging the battery while it is installed in the bike.
Recommended ambient temperatures for charging and storing the battery safely.
Instructions for charging the battery when removed from the bike.
Details on battery status, charger indicators, error codes, and charging times.
Step-by-step guide on how to properly pack the bicycle into the BikeBox for transport.
Details on routing cables and the fork stop mechanism for the EP801 cockpit.
Explanation of the EP801 cockpit display, power modes, and control functions.
Details on routing cables and the fork stop mechanism for the EP6 cockpit.
Explanation of the EP6 cockpit display, power modes, and control functions.
Details on routing cables and the fork stop mechanism for the EP8 cockpit.
Explanation of the EP8 cockpit display, power modes, and control functions.
Steps for initial assembly adjustments and tuning suspension elements for optimal performance.
Understanding sag, safety warnings, pre-ride checks, and crash procedures for safe operation.
Advice on getting to know your bike, pre-ride checks, and riding regulations.
Guidance on country-specific regulations for riding YT bikes on public roads.
Information on the intended use of the bike and following component manufacturer instructions.
Important safety, operation, and regular care and service interval guidelines.
Detailed checklist for monthly and annual inspections and component checks.
Essential instructions for handling carbon frames, preventing damage, and inspection requirements.
Guidelines for correct handling of seat post, seat clamp, handlebars, and rear wheel axle.
Precautions and methods for safely transporting bikes with carbon frames.
Information on protective foils and shields for carbon frames and their maintenance.
Proper procedures for disposing of used batteries and electronic equipment according to regulations.
Important instructions and precautions for charging the bike's battery, including best practices.
To Next Page
