Cont : Continue to run the program from the original break point. If STOP STATUS
was activated before power cut, then it (the program) will keep stop status after power
restart.
StoP : Stop the program after power restart
run1 : Start to run the program from step 1 unless the instrument was in “stop” state
before power cut.
d AS t : If these have deviation alarm after power resume, then stop the program,
otherwise, continue run the program from the original break point.
HoLd : Go into HOLD state after power on. If it is in StoP state before power cut, then
keep in StoP State after power on.
To Next Page
Loading...