2. Cleaning the main brush
3. Display window error messages & solutions
Check
display
Cause Solution
C 1
Move eX500 to a flat area.
C 2
Move eX500 to a flat area in case the wheel was stuck on a
obstacle.
C 3
Dust bin is not properly assembled or installed.
C 4
Check if a foreign material such as hair or lint is caught in the wheel
and remove the material.
C 5
Check if a foreign material such as hair or lint is caught in the main
brush or side brush and remove the material.
C 6
Clean filter, empty the dust bin.
C 7
Turn off the power switch of the robot cleaner then turn it on again.
Lifted wheel
Cannot detect floor
Dust bin error
Wheel motor overload
Brush motor overload
Suction motor overload
Internal system error
YCR-M05
Quick Start Guide
Robotic Vacuum Cleaner eX500
■The complete user manual is also available to download on our website
www.yujinrobotusa.com
www.yujinrobotusa.com
eX500 care & maintenance
1. Regularly empty the dust bin and replace the antibacterial filter
Magnetic Sensor
Check that the front wheel and magnetic sensor are clean and
correctly installed.
C 8
iAQG.USA.500.V1
Furrow
CLICK
To Next Page
Need help?
General
