the eyepiece (4) and rotating the objective lens (5). After the adjustment, do not rotate the
eyepiece irrespective of the distance and other conditions.
• Direct your NV 2x24 device at the subject to be viewed and adjust the final focus by rotating
the objective lens (5) focusing ring until the image quality is optimal.
• The unit has a LED indicator performing two functions. The green light indicates that the unit
is on. When you turn on the IR illuminator, the LED indicator changes its color from green to
red. To turn off the device and the IR, push the “ON” button - the LED indicator will go out.
Affix the lens cap back to the objective lens.
CAUTION!
Your Patrol 2x24 can be used in extreme cold. However, when the unit is brought back into awarm
environment, you must wait approximately 2-3 hours before using the unit again. Failure to do so
may result in damage as a result of condensation accumulating on the internal circuitry of the unit.
MAINTENANCE
Maintaining the Patrol 2x24 is simple:
• Clean the lens with professional lens cleaning supplies intended for use with multicoated optics.
• Blow any dust or dirt off the lenses using dry, compressed air.
• Clean the Patrol 2x24’s housing with a soft, clean cloth.
STORAGE
Always store the Patrol 2x24 (in its case) in a dry, well-ventilated area away from heating/air
conditioning vents (or other heating devices). Temperature should be higher than +10°C. Humidity
should not exceed 70%. Remove the battery if the device is to be stored for longer than 2 months.
TROUBLESHOOTING
The scope will not turn on...
Check that the batteries are installed properly. Install the batteries according to the (+) and (-)
polarity, ensuring that the markings on the battery and battery compartment correspond with one
another. Check the battery contacts to ensure they are clean and free of corrosion; if necessary,
To Next Page
Loading...
