-FLAT：It is 709 like curve with color information, and lower the contrast for easy
post processing.
-HLG(Hybrid Log-Gamma): Encode the high-light and low-light parts of the HDR
signal in two different ways in which the low-light part use the standard gamma
curve and the high-light part use the logarithmic curve.
Sharpness: Strong / Medium / Week, default Medium.
Brightness: 0~100, default is 50.
Saturation: 0~100, default is 50.
Contrast: 0~100, default 50.
Luminance Level: Full / Limited. The range of luminance level is 0~255 when it’s set
to Full, and 16~235 when it’s set to Limited.
2.9. Connect
Network: there are sub-items as below:
Wi-Fi: Off / On. When the Wi-Fi is activated, here will show the Wi-Fi ID, which
is ZCAM-E2-XX-XXXX (last four digits which match to the camera ID), and the
default password is: 12345678, which can only be changed with iOS app (6.
UsingZCameraApp)
Wi-Fi IP: Here will show IP address of the Wi-Fi when it’s is activated.
ETH. Mode (Ethernet Mode): Direct / Router / Static
- Router: Camera is connected to the computer through a router, IP
address will be assigned by the router.
- Direct: Camera is connected to the computer directly through Ethernet
To Next Page
Loading...
