13
Note: To securely attach a mount please ensure you read the following instructions
below:
Attach adhesive mounts 72 hours before use (24 hours minimum) to ensure a strong ·
bond.
Adhesive mounts must be mounted on smooth surfaces to ensure a proper bond.·
Apply adhesive mounts to clean surfaces only - wax, oil or dirt will weaken the bond.·
Firmly press adhesive mounts into place and ensure full contact over the entire ·
surface.
Attach adhesive mounts in room temperature conditions.·
Loop the circular ring of the Tether over the thumbscrew of the camera housing and ·
attach the other end to a secure anchor point. This will help prevent losing the
camera if it accidentally releases. To avoid injury do not use tether if attaching
camera to a helmet or other personal protective gear.
Mounting Accessories
· 2x Velcro Straps
2x Buckle Straps·
4x Cable Ties·
1x Tether·
2x Replacement Adhesive Pads·
1x Cleaning Cloth·
1X Clip Mount·
To Next Page
Loading...
