2
1. Connect the module into the vehicle’s OBD-II
port. The OBD-II port is located under the
dashboard on the driver’s side.
2. Start your vehicle.
3. The module will begin to boot and the LED
will ash for 5 seconds.
4. When the module is ready to use the green
LED will ash for 5 seconds and then turn off.
5. If you need to disconnect the module and
plug it back in, you will need to follow the boot
sequence again. Make sure the module is
turned off before removing it.
OBD-II MODULE INSTALLATION
This warranty protects the product(s) specied to be free
from defects in material and workmanship for 1 (one) year.
During the warranty period we will, at our sole discretion,
repair or replace the product(s). This limited warranty does
not cover travel expense or labor charges for the removal and
reinstallation of the product, or any other charges alike. We
are not responsible for incidental damages, including but not
limited to: loss of time, loss of work, inconvenience, loss and/
or damage to personal property, shipping expenses. We are in
no way responsible for any loss or any indirect or consequential
damages resulting from any such defect in material and/
or workmanship whether it’s due to negligence, incorrect
installation, or manufacturer mistake. It is the sole responsibility
of the party initiating a warranty claim to pay shipping charges
associated with returning a product.
• If you do not know what you are doing, do not try.
• We advise professional installation for all products.
• Electrical shock can cause injury or death. Please use proper
tools and protection when installing. Professional installation
is strongly advised.
• Please check for correct installation method
before powering on. Electrical re can occur.
• Do not run any wires in the way of air
bags or other safety devices.
Warranty: Warning:
To Previous Page
Loading...