43
61335M Main Logic Board Maintenance Kit
Open the Printer
5/8/08 HC100 Maintenance Manual 61311L-001 Rev. A
Open the Printer
1.
2.
Place the printer on the antistatic mat.
3.
4.
See Figure 19. Press the upper cover release buttons located on both sides of the printer.
Figure 19 • Opening the HC100
Caution • A qualified service technician must perform this installation.
Caution • Observe proper electrostatic safety precautions when handling
static-sensitive components such as circuit boards and printheads.
Connect yourself to an antistatic device.
Caution • Turn off (O) the printer and disconnect it from the power source before
performing the following procedure.
Turn off (O) the printer and disconnect the DC power cord and all data cables.
1
Upper cover release button (one on each side)
1
To Next Page
Loading...
