115
Printer Configuration and Adjustment
Adjust Printer Settings—Sensor Settings
10/7/16 ZT410 RFID Printer for Silverline Media User Guide P1089083-001
TAKE LABEL
Take Label
Sensor
Set the intensity of the take label LED.
Important • This value is set during sensor calibration. Do not change this
setting unless you are told to do so by Zebra Technical Support or by an
authorized service technician.
User menu item:
Main Menu >
SENSORS
Accepted values:
0 to 255
SGD command used:
ezpl.take_label
Printer web page: View and Modify Printer Settings > Calibration
Table 9 • Sensor Settings (Continued)
To Next Page
Loading...