Installation Guide 11
To ensure the TC75 was inserted correctly, listen for the
audible click that signifies that the TC75 locking mechanism
was enabled and the TC75 was locked into place.
To remove the TC75 from the cradle, press the release latch,
grasp the TC75 and lift out of the vehicle cradle.
TC75 Battery Charging
Ensure the vehicle cradle is connected to a power source.
See USB I/O Hub Power on page 9.
Insert the TC75 into the cradle. The TC75 starts to charge
through the cradle as soon as it is inserted. This does not
deplete the vehicle battery significantly. The battery charges
in approximately four hours. See LED Indicators on page 12
for all charging indications.
Charging Note
The Vehicle Cradle operating temperature is -40°C to +85°C.
When in the cradle, the TC75 will only charge when its
temperature is between 0°C to +40°C.
CAUTION Ensure that the TC75 is fully inserted
into the cradle. Lack of proper insertion
may result in property damage or
personal injury. Zebra Technologies
Corporation is not responsible for any
loss resulting from the use of the
products while driving.
To Next Page
Loading...