Installation Guide 3
Introduction
This guide describes how to install and use a
CRD-TC7X-DCVH-01 Vehicle Cradle with a TC75 touch
computer.
Install the cradle into a vehicle. Once installed, the cradle:
• holds the TC75 securely in place
• provides power for operating the TC75 when connected to
the optional USB I/O Hub.
Requirements
For mounting on a flat surface:
• four M3 screws (included)
• four wall anchors (not included).
For mounting onto a RAM Mount
®
:
• RAM Mount (sold separately)
• Four M4 screws, lock washers and flat washers
(included).
To Next Page
Loading...
Need help?
General
