Zebra TC7X Series - Mounting to a RAM Mount

8 TC7X Vehicle Cradle Installation Guide
Mounting the Cradle to a RAM
Mount
To mount the cradle onto a RAM Mount:
1. Follow the instructions that are provided with the RAM
Mount for RAM Mount mounting instructions.
2. Align the vehicle cradle with the RAM Mount ball base.
3. Secure the vehicle cradle to the ball base using M4
screws, lock washers and flat washers (provided)..
CAUTION Only mount the Vehicle Cradle in a
vertical position. Never mount the
vehicle cradle on the side or upside
down or on a wall that can be subject to
impact or collision of greater than 10Gs,
in accordance with SAE J1455 Section
4.10.3.5.
CAUTION Do not install a Vehicle Cradle on or
near an air bag cover plate or within an
aerobic zone. Also, do not install it in a
location that affects vehicle safety or
driveability.