P1096702-001 • ZQ320 Repair Procedures • 2-28 •
Installing the Printhead
1. Connect the Printhead Assembly to
the Printhead Bracket by sliding the
printhead ribbon cable through the
opening in the bracket (as shown).
2. Use a T6 TORX driver to secure two
(2) screws to connect the printhead to
the bracket.
3. Place two (2) springs on the Spring
Bar (as shown).
4. Install the Spring Bar Sub-Assembly
to the Printhead Sub-Assembly,
making sure that the springs rest on
the tabs on the back of the Printhead
Sub-Assembly.
To Next Page
Loading...