P1096702-001 • ZQ320 Repair Procedures • 2-30 •
Repair Kits P1093300-005, -006 & -007
Installation Instructions
This kit includes the parts necessary to install Main Logic Board and Top PCBA with
BT4 and 802.11AC Radio. Read these instructions thoroughly before attempting to
install this kit.
Tools Required
• T-6 TORX Driver (3.0 +/- 1 in. lb.), 4mm Hex Nut Driver (4.7 +/-1 in. lb.)
Removing the Main Logic Bd. & Top
PCBA
1. To remove the Top PCBA, use a T6
TORX driver to remove the three (3)
screws (circled) securing the board
to the Main Logic Board (MLB).
2. Disconnect the Top PCBA from the
MLB and lift it away from the MLB.
3. Use the T6 driver to remove the
single screw on the MLB (where
shown).
6.
To Next Page
Loading...