Connections
5-5CenterMax Operating Instructions61211-1020202
Pressure gages
There are five pressure gages for five devices. These devices and their
required pressures are listed below:
1 Compressed-air connection to the CMM
2 Air filters; coarse and fine
3 to 7: Compressed-air gages and connectors for five
different devices
8 Pressure controller
Important!
The valves of pressure gages which are not connected must be closed.
The connection shank should be covered by a cap.
231 45 678
Indicated pressures:
Device No.
Required pressure
a
y drive 3 2bar
Weight balancer 4 5bar
Option: 5 5bar
Option: e.g. loading device 6 5bar
Air bearings in the CMM 7 5bar
a
The values set by the ZEISS service engineer may slightly deviate from the indicated
values.
!
To Next Page
Loading...
