Installation Instructions
Page
11
4.3 Installation of Floor Stripe or Chain
The dangers posed by the CMM are impossible - or at
least difficult - for untrained personnel to recognize. For
this reason, a restricted-access zone must be set up
around the machine to prevent damage or injury caused
by untrained personnel.
The entrance to this area should be be clearly marked by
a warning sign reading:
"Admittance only for authorized personnel"
and may be entered only by persons who have received
proper training (operators).
Floor marking or chain
(black-and-yellow)
d
Controller
c
c
The back door of the controller cabinet must
be located at least 200mm away from the wall.
Moreover, the air exchange with the surround-
ing environment should not be blocked. The control cab-
inet should be placed so that the rear side of the
controller always faces away from the CMM.
d
CMM table (optional) with computer and printer
To Next Page
Loading...
