Zeiss CONTURA G2 - 4.4 Arrangement of the Steel Plates for Contura G2

Page
12
Installation Instructions
276
674
1070
244
CONTURA G2
X=700, Y=1000
1032
219
521
822
244
CONTURA G2
X=700, Y=700
1032
311
773
1234
299
CONTURA G2
X=1000, Y=1200
1192
389
973
1556
299
CONTURA G2
X=1000, Y=1600
1192
493
1232
1971
297
CONTURA G2
X=1000, Y=2100
1186
Floor load on the supports (A)
CONTURA G2
X=700, Y=700 34.8 N/cm
2
X=700, Y=1000 43.1 N/cm
2
CONTURA G2
X=1000, Y=1200
65.4 N/cm
2
X=1000, Y=1600
81.5 N/cm
2
X=1000, Y=2100
132.1 N/cm
2
CONTURA G2 w. granite U-table (option)
X=1000, Y=1200
70.6 N/cm
2
X=1000, Y=1600
88.2 N/cm
2
X=1000, Y=2100
143.1 N/cm
2
Support (A): Cast iron plate Ø 150
(included in delivery)
4.4 Arrangement of the Steel Plates for Contura G2
The relative unevenness of the bearing surfaces must not exceed max. 25mm (1“)..
The deviation tolerance for the center-to-center plate distance is (A) ±10 mm (all dimensions in mm)
Point of support (tilt protection only)