Zeiss CONTURA G2 - Preparation for installation;Required connections;Transport;Storage; 2.1 Preparing the Floor Surface; 2.2 Electric Power Supply; 2.3 Electric Power Supply Parameters

Page
4
Installation Instructions
consult a statics engineer who is familiar with your local
floor conditions. To determine the floor load exerted by
the CMM, see the pertaining information in this bro-
chure.
0,1
1
10
100
1000
0
10 20 30 40 50
X axis horizontal
Y axis horizontal
Z axis vertical
Permissible foundation acceleration for
Contura G2 w. trigger probe and standard damping
Acceleration values above the curve
require an additional foundation
Acceleration [mm/ss]
Frequency [Hz]