Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
Guided Progression Analysis (GPA)
8-29
How To Print GPA Reports
Before you can print GPA reports, you must have a GPA license and it must be activated. See “How
to Activate GPA Software on the HFA II-i,” on page 8-35 for instructions on how to acquire and
activate a GPA license. Once your GPA license is activated, the basic steps to
print GPA reports are:
• Step 1
: Select a valid Follow-up exam. See “Step 1: Select a Valid Follow-Up Exam,” on
page 8-30. The exam you select is the “Key Exam.” Full Thr
eshold, SITA Standard, and SITA Fast
exams can all be used as Follow-up exams depend
ing on the Key Exam chosen.
• Step 2: Select r
eports from the Threshold Printout Selection Screen. See “Step 2: Select Reports
from Threshold Printout Selection Screen,” on page 8-31. You may print the report at this time,
or continue to Step 3.
• Step 3: M
odify the GPA Exam Selection (Optional). Change the Baseline selection and
add/remove exams from Follow-up. See “Step 3: Modify the GPA Exam Selection (Optional),”
on page 8-32. You may choose to print at the end of this step.
If a GPA report is not available (i.e., if there are not enough exams
for the selected patient and eye),
you will be returned to the print menu to make another selection.
Default GPA Report Options
After your GPA software has been licensed, the GPA Summary w
ill be printed by default. To change
which reports are selected by default whenever you enter the Threshold Printout Selection menu, do
the following:
1From the Main Menu screen, select
SYSTEM SETUP
>PRINT
SETUP>DEFAULT GPA PRINT OPTIONS.
2On the Default GPA Print Options screen, select which report(s) you
would like to be selected by default by clicking in the button next to
the report so that an X is displayed in the button. For the first and last
buttons, select the report from the drop-down menus.
3Press Done.
Your selection will be retained until you change it again.
To Next Page
Loading...
