Zeiss Humphrey II-i series - Erasing Grids or Single Points; Saving Custom Tests

Humphrey Field Analyzer II- i series User Manual 2660021145640 A
Custom Testing
12-11
Erasing Grids or Single Points
Please read this entire section before removing any poin
ts. You can remove unwanted Grids or
Single Points from a Custom test that you are creating. However, you can remove only the last entry.
If you input a Single Point or Grid that you are unsure of, it is best to erase it and input it again later.
The ERASE LAST ENTRY button is disabled if there are no points created already.
1From the Custom screen, press ERASE LAST ENTRY.
The last Single Point or Grid you have entered will automatically be
r
emoved from the test field. No warning will be issued before deleting
the last entry.
2Subsequent selections of the ERASE LAST ENTRY button will delete
the next previous entry. By repeating this process, you can remove
Grids or Single Points in the reverse order from which they were
created.
Saving Custom Tests
When you have entered all desired test points, you must sa
ve the test. Saving the Custom test
pattern you programmed creates a test button on the Custom Test screen which is specific to that
test. This button is used to recall the test pattern for future use. Be sure to save your Custom test
pattern, using the method that follows.
1From the Custom screen, select SAVE TEST.