EasyConnect RCT 1.0
Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
G-6
Easy Mode (default)
Easy mode configures a set of instruments by setting up all their shared folders or shared printers in
a few steps. Standard defaults are provided for all entered configuration data. The default RCT User
Name is “Zeiss” and the default RCT Password is “November171846”. All licensed features will be
configured.
Note: It is strongly recommended that you use Easy mode to conf
igure your HFA if it is not already
using networking features.
Note: If you have a previously created User Account with the User Name “Zeiss” and a password
different than the default RCT Password “November171846”, you will need to use Custom mode and
enter the correct password for the “Zeiss” User Account. If this may be the case, a dialog will be
displayed alerting you and allowing you to continue or enter Custom mode.
The following steps describe how to config
ur
e your instruments using Easy mode.
1 Select EASY from the SELECT A CONFIGURATION MODE radio buttons (Figure G.4) and then select
NEXT to continue.
Figure G.4 Select Easy Configuration Mode
To Next Page
Loading...
