Zeiss Humphrey II-i series - Page 459

Humphrey Field Analyzer II- i series User Manual 2660021145640 A
EasyConnect RCT 1.0
G-19
The RCT displays a message alerting you there will be a delay before proceeding (Figure G.20).
Figure G.20 Please Wait Message
5 If the PERFORM CONNECTION TESTS button was not selected (default), then after selecting NEXT
on the Commit screen, a final Completion screen will be displayed (Figure G.21). If you selected
PERFORM CONNECTION TESTS, then each selected instrument will be tested before a final
Completion screen will be displayed (see Steps 3–5 in the Test mode section, page G-38–
G-42).
Each connection test could take several minutes . Select FINISH to exit the RCT.
Figure G.21 Completion Screen (No connection tests)