Humphrey Field Analyzer II-
i
series User Manual 2660021145640 A
EasyConnect RCT 1.0
G-31
Report Mode
Report mode displays the configuration of a selected set of instruments. Any user can run Report
mode—the user does not need to be an Administrator. The following steps describe how to use
Report mode.
1 Select REPORT from the SELECT A CONFIGURATION MODE radio buttons (Figure G.36) and then
select
NEXT to continue.
Figure G.36 Select Report Configuration Mode
The RCT displays a message alerting you there will be a delay before proceeding (Figure G.37).
To Next Page
Loading...
