Zeiss Humphrey II-i series - Setting up Your HFA Network

Networking Reference
Humphrey Field Analyzer II- i series User Manual 2660021145640 A
I-4
Setting Up Your HFA Network
Note: It is strongly recommended that you use the EasyConnect RCT in Easy Mode instead of
manually configuring your network settings on your HFA II-
i instruments (see “EasyConnect RCT
1.0,” on page G-1).
You may set up your HFA network to work with Link-Local, DHCP, or STATIC IP.
The following describes the procedures.
1 Go to the Main Menu, select SYSTEM SETUP (Figure I.2).
Figure I.2 Main Menu Screen
2 On the System Setup screen, select COMMUNICATIONS SETUP (Figure I.3) to open the
Communications Setup menu.
Figure I.3 System Setup Screen