Zeiss Humphrey II-i series - Installing Additional Software

Humphrey Field Analyzer II- i series User Manual 2660021145640 A
Installing & Licensing HFA II-i Software
J-3
Installing Additional Software
Occasionally, additional software packages become available for the HFA II- i which do not require a
full system software upgrade to take place. The following instructions describe the steps to install an
optional software feature, such as the Kinetic test feature. Do not use this method for full system
software upgrade installations.
1 From the Main Menu, select the SYSTEM SETUP icon. On the System Setup menu, select
ADDITIONAL SETUP. Next, select INSTALL SOFTWARE.
Figure J.2 Additional Setup Screen
2 Select INSTALL SOFTWARE FROM USB MEDIA on the Install Software screen. A dialog box will
be displayed as shown in Figure J.3. below.
Figure J.3 Beginning an Installation
3 Insert the Carl Zeiss Meditec USB flash drive that contains the optional software feature to be
installed. Press OK when ready, as indicated on the screen.