MCS 600 Network Connection
MCS 600
4 MCS 600 Network Connection
We recommend using a CAT 6 S/FTP patch cable for establishing network connec-
tions with the MCS 600.
Note
If the device is connected directly to an older ethernet adapter without
auto MDI-X, a crossover patch cable must be used.
Connections are made via TCP and port 7890. Please make sure your firewall
settings are configured accordingly.
If your network supports UDP commands, you can search the network for the ad-
dress of a connected device. To do this, you can use the SMC program included
in the standard software packages (e.g. Aspect plus and InProcess). In the right-
hand section of the SMC program, there is an input field where you can enter
the IP address of the device you wish to use. Next to the input field is a button
labeled "Scan".
To Next Page
Loading...
