Technical instructions ZELIA ZLT
16
7.10. Production level
The produced chlorine quantity is limited by the daily filtration time (as the salt chlorinator runs
together with the filtering pump thanks to its flow switch). In case of a lack of chlorine it is first
necessary to check the daily filtration time. It is also possible to change the production level. Re-
ducing the production level if it is too high (for small pools i.e...) will increase the lifespan of the
cell. Rising this level will increase the chlorine production but decrease the lifespan of the cell.
To set this parameter:
1.
Press the keys
and until o7 is displayed.
2.
Validate with the key
.
3.
Adjust the parameter with the keys
and (see table bellow).
4.
Validate with the key
.
Required production level
Value to enter under parameter o7
30%
n1
40%
n2
50%
n3
60%
n4
75%
n5
90%
n6
Nominal (100%) (factory default)
n7
110%
n8
Maximal (125%)*
n9
After 10s the display automatically returns to the normal mode (standby: display of the temperature,
error and mode).
*It is recommended to limit the use of the production levels
n8 and n9
To Next Page
Loading...
