RECORDYOUR MODEL NUMBER/
The model and serial number of your
Entertainment Machine TM are Located on the
back of the TV cabinet. For your future conve-
nience, we suggest that you record these num-
bers here:
Mode[ No.
Serial No.
WARNING:
TO REDUCETHE RISK OF ELECTRICSHOCKDO NOT REMOVECOVER(OR BACK). NO USERSERVICEABLEPARTSINSIDE.
REFERSERVICING TO QUALIFIED SERVICEPERSONNEL.
The Lightning flash with arrowhead symboL, within an equilateral triangle, is intended to alert the user to the presence of
uninsuLated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of
electric shock to persons.
The exctamation point within an equilateral triangle is intended to alert the user to the presence of important operating and
maintenance (servicing) instructions in the literature accompanying the appliance.
WARNING:
TO PREVENTFIRE OR SHOCK HAZARDS, DO NOT EXPOSETHIS PRODUCTTO RAIN OR MOISTURE.
POWER CORD POLARIZATION:
CAUTION:Toprevent electric shock, match wide bladeof plug to wide slot, fully insert.
ATTENTION: P
correspondante de La prise et pousser jusqu'au fond.
NOTETO
CABLE/TV INSTALLER:
This reminder is provided to call the cable TV system instaLter's attention to ArticLe 820-40 of the National ELectric Code
(U.S.A.). The code provides guidelines for proper grounding and, in particular, specifies that the cable ground shaLLbe
connected to the grounding system of the building, as close to the point of the cable entry as practicaL.
REGULATORY INFORMATION:
This equipment has been tested and found to comply with the timits for a CLassB digital device, pursuant to Part 15
of the FCCRuLes.These Limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a residential instaLLation. This equipment generates, uses and can radiate radio frequency
energy and, if not instaLLed and used in accordance with the instruction manuaL, may cause harmful interference to radio
communications. However, there is no guarantee that interference wiLL not occur in a particular instaLLation. If this
equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or more of the foLLowing
measures: • Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• ConsuLt the dealer or an experienced radio/TV technician for help.
CAUTION:
Do not attempt to modify this product in any way without written authorization from Zenith ELectronics Corporation.
Unauthorized modification could void the user's authority to operate this product.
COMPLIANCE:
The responsible party for this product's compliance is:
Zenith ELectronics Corporation, 2000 MilLbrook Drive, LincoLnshire, IL 60069, USA • Phone: 1-847-941-8000.
To Next Page
Loading...
Need help?
General
