Page 12 of 15
Velco fastener and straps.
3. Connect the cable with battery tightly. Avoid cross threading by applying a small
amount of grease or oil to the threads. With use the threads will move easier.
4. Put the harness on by securing cross buckles and belt. The holster is designed to be
looped through the belt.
5. To prevent the pruner power cord from tangling or getting cut, run the cord on the
inside of your coat sleeve or use the provided Velcro cord straps.
6. Connect the cable with pruner tightly. Avoid cross threading by applying a small
amount of grease or oil to the threads. With use the threads will move easier.
7. Grip the pruning shear handle tightly
8. Turn on the power switch; pull the trigger 3X in fast sequence, blade will open. The
pruner is designed this way to avoid errant activation of the pruner.
Working Environment
：
1. Keep environment temperature at 32
°
F ~ 113
°
F when charging battery, keep 14
°
F ~
+140
°
F.
2. Keep tool between 23
°
F ~ 86
°
F.
Operation
：
Please wear suitable clothing and gloves when operating this tool. Threading the
power cord through a picking sleeve or using provided Velcro cord straps will
prevent the cord from tangling or getting cut. Always check tool before use, make
sure on/off switch and safe switch are all ok. Release the trigger for the cutting
blade to return to its resting position.
Check blade frequently to keep it clean and sharp. A clean sharp blade will
increase performance and extend the life of the tool.
Switch tool off, make sure blade is fully stopped before servicing. Do not touch the
blade with your hand when power is on.
1. The output direction of the cable and the direction for holding the pruner should be
connected on the same side. You can connect to right side if you are right handed or
left side if you are left handed.
2. Adjust your backpack and fasten your belt securely.
3. Connect the cable with pruner tightly.
4. Turn on the power switch. After tone, rapidly pull the trigger three times without
holding. If the pruner does not activate, check whether the wire connecting the pruner
To Next Page
Loading...
Need help?
General
