EN
12
ITEMS IN THE BOX
1. AqueenaPro water fi ltration system 1 piece
2. RO membrane in protective fi lm 1 piece
3. Power supply adaptor 1 piece
4. User manual 1 piece
5. Drinking water faucet 1 piece
6. Tube 5 m
7. Drainage clamp 1 piece
8. Wrench for membrane housing 1 piece
9. Accessory bag 1 piece
a) Inline feed water connector 1 piece
b) Clip for quick connectors 2 pieces
c) Faucet fi xture 1 piece
AQUEENAPRO INSTALLATION
Installation, servicing, maintenance and repairs should only be performed by
Zepter authorised staff.
All maintenance should be performed using original Zepter replacement cartridges and spare parts.
Warning!
• Avoid exposure to direct sunlight and installation in damp areas
It may create a breeding ground for microorganisms resulting in reduced purifi ed
water quality, as the internal components of the water purifi er can be polluted
• Inlet water cannot exceed 38°!
Using a hot water source (>38°C) will cause permanent damages to the RO
membrane and severely degrade the performance of the product.
Make sure that AqueenaPro is connected to a cold water supply only.
• The maximum distance between the water source and the
purifi er should not be more than 3 m.
• Avoid sharp bends in the pipe. Do not bend or block the
reject water tube.
• Do not confi ne your AqueenaPro in a tight cabinet.
• Do not use the AqueenaPro when the drain is clogged up.
• Do not use AqueenaPro at temperatures below 5°!
If the room temperature is below 5°, it can result in pipes cracking due to water
freezing inside the machine.
To Next Page
Loading...