EN
18
TROUBLE CAUSE SOLUTION
While working, an accessory detaches itself. The accessory is not correctly connected. Check that the accessory is correctly connected.
Vacuum power is too low or performance goes
down while working with the vacuum.
A filter is dirty blocking intake. Check and clean filter.
The filters are not properly mounted. Check filter and if necessary reposition.
Air is coming in where it should not.
Check that the cover, hose and accessories are
correctly mounted and fastened.
The gasket along the water bucket is not properly
positioned.
Reposition correctly the gasket between the
bucket and cover.
The hose or an accessory is obstructed by dirt. Check and free the passageway.
The pivoting front wheel passage is obstructed. Check and free the passageway.
The motor works correctly but vacuum
performance is poor.
The floater is closing the air passage.
Empty the water bucket and fill up to minimum
level with clean water.
The hose or accessories smell unpleasant.
Dirt and grime has accumulated in the hose,
accessories or bucket.
Clean all parts with clean water and if necessary
light detergent, but make sure to clean and dry
after each use.
12 - TROUBLESHOOTING
To Next Page
Loading...