Zepter Tuttoluxo 6S cleanSy PWC-700 User Manual (English)

Questions and Answers:

M
Michele SchneiderAug 1, 2025
Why is the Zepter Vacuum Cleaner vacuum power too low?
- M
  Michael ArmstrongAug 1, 2025
  Low vacuum power in your Zepter Vacuum Cleaner can stem from several causes: * A dirty filter blocking intake. You should check and clean the filter. * Improperly mounted filters. Check and reposition the filter if needed. * Air entering where it shouldn't. Ensure the cover, hose, and accessories are correctly mounted and fastened. * A mispositioned seal along the water bucket. Correctly reposition the seal between the bucket and cover. * An obstructed hose or accessory. Check and clear any blockage. * An obstructed pivoting front wheel passage. Check and clear the passage.
L
lisa02Aug 7, 2025
What to do if Zepter Tuttoluxo 6S cleanSy PWC-700 Vacuum Cleaner hose or accessories smell unpleasant?
- M
  Michael KerrAug 7, 2025
  An unpleasant smell from your Zepter Vacuum Cleaner's hose or accessories indicates that dirt and grime have accumulated. Clean all parts with clean water and, if necessary, a light detergent. Make sure to clean and dry after each use.
E
Eric TurnerAug 13, 2025
What to do if Zepter Vacuum Cleaner accessory detaches itself during work?
- P
  powellmaryAug 14, 2025
  If an accessory detaches itself during operation of your Zepter Vacuum Cleaner, the accessory is not correctly connected. Check that the accessory is correctly connected.
Z
Zachary ClarkAug 19, 2025
Why no steam comes out of my Zepter Tuttoluxo 6S cleanSy PWC-700 Vacuum Cleaner?
- S
  Scott Anderson PhDAug 19, 2025
  If the steam ready LED is on but no steam is coming out of your Zepter Vacuum Cleaner, the hose is not completely connected. Check the hose is correctly fitted to the appliance. Alternatively, the steam regulator is completely closed. Open the steam regulator.
H
heatherparkerAug 25, 2025
How to fix Zepter Tuttoluxo 6S cleanSy PWC-700 flashing LED for low water level?
- J
  Joe BlackburnAug 26, 2025
  If the LED for low water level is flashing and you hear an acoustic signal after connecting your Zepter Vacuum Cleaner, the water level in the tank is low. Unplug the machine, fill up the water tank, and plug it in again.

Zepter Tuttoluxo 6S cleanSy PWC-700 Specifications

General

Model	Tuttoluxo 6S cleanSy PWC-700
Category	Vacuum Cleaner
Water Filtration	Yes
Steam Cleaning	Yes
Air Purification	Yes
Pressure	450 kPa
Cord Length	8 meters
Filters	HEPA Filter