UNPACKING
Place the appliance in the upright position which can be easily identified by reading the direction mark “UP” on the
box.
Open the package and check that there are no dents or obvious damages to the appliance caused by transportation.
Any defects must be notified within 24 hours from delivery.
In case of obvious defects or dents, do not install the appliance.
The packaging must be disposed of by the customer in accordance with current environmental protection regulations.
(030)
POSITIONING
Position the cooler in a clean, ventilated place and keep away from heat sources.
Leave a gap of at least 5 cm on each side and 25 cm by the ventilation slots.
If the ventilation slots are covered, the cooling system cannot operate properly and this inevitably leads to
malfunctioning.
Do not place any objects on top of the product.
Caution: non-compliance with the above conditions causes the compressor to overheat and break, leading
to immediate invalidation of the warranty.
For proper installation and use of the appliance, refer to the “First power on” paragraph.
(040)
Specification for model Refresh Pensile
This product needs to be wall mounted. Position the machine in an open place, away from heat sources.
Leave a gap of at least 20 cm on each side (except on the side against the wall).
Once established the height, drill two holes 12mm in diameter with centre distance of 220mm.
To Next Page
Loading...