Zetor 10641 Forterra turbo - Donřt Have Sufficient Technical Equipment Draining Openings and Plugs; Let to Do more Complicated Work in the after Draining the Oil; Planned Technical Maintenance. if You Changing and Inspecting the Transmission Oil

177
MAINTENANCE INSTRUCTIONS
F 256 F 257 F 258
CHANGING AND INSPECTING THE
TRANSMISSION OIL
The oil level is inspected by oil dipstick
located on the right side of differential
case.
Filling opening for transmission oil is
located on the hydraulic
rockshaft. This
is accessible from the rear of tractor.
DRAINING OPENINGS AND PLUGS
1 - Oil from clutch housing
2 - Oil from gearbox
3 - Oil from differential case
AFTER DRAINING THE OIL
- Clean magnetic element (1) and
strainer (2).
- Exchange the paper cartridge (3).
Tighten the screw of cleaner bowl by
hand. Do not use tools.
- Assemble all draining plugs after their
cleaning.
- Fill the oil (approximately 40 litters)
start the engine and let it run
approximately for 2 minutes.
- Check the level and add the oil up to
the maximum level after stopping the
engine and stabilizing the oil level in
transmission.
PDF byl vytvoren zkusebnı verzı FinePrint pdfFactory http://www.fineprint.cz