93
TRANSPORTATION
F 135 F 136
AUTOMATIC MOUTH OF TRAILER
HITCH
For attaching the trailer do the following -
pull out the latch (1) and simultaneously
raise the main hitch pin (3) into its upper
position by means of lever (2). Pin
automatically slides into trailer yoke eye
after coupling the mouth and yoke. Be
sure the latch is back in position after
coupling trailer.
Maximal allowed vertical static load is 10
kN.
SWINGING DRAWBAR
Swinging
drawbar can be set side to
side in 5 positions by 80 mm. Drawbar is
fixed by the clevis in desired position.
The drawbar can be longitudinally set in
two positions - measured from the end of
PTO shaft (350 or 400 mm).
Cross bar above the drawbar enables an
operation with implements requiring the
floating position of swinging drawbar
(with disassembled clevis)
Maximal vertical static load of drawbar
clevis is 12 kN.
PDF byl vytvořen zkušební verzí FinePrint pdfFactory http://www.fineprint.cz
To Next Page
Loading...
