123
HYDRAULIC WITH MECHANICAL CONTROL SYSTEM
F_02_H7 F_02_H8 F_02_H9
CAB CONTROL SWITCH
Cab control switch is used for lifting the
implement when turning the tractor in the
end of field. Pressing the switch lifts im-
plement. Implement is lowered into pre-
vious position destined by inner circuit
lever after turning the switch into off.
CONTROL SWITCH ON FENDER
Control switch on fender makes attach-
ing the implement easy. Driver can han-
dle movement of three point hitch lower
links from outside. The hitch is lifted
when the switch is pressed. The imple-
ment is lowered into previous position
destined by inner circuit lever after re-
leasing the switch.
When the tractor is equipped
witch pick up hitch do not lift the
rear three point hitch by switches
on fenders up to the highest po-
sition! Danger of damaging the
hitch!
USE OF SWITCHES
Operator must stand outside the
operating range of attached im-
plement when manipulating with
three-point hitch by means of
electrical switches to avoid
catching by implement or injury
For lifting the implement into transport
position you must use the control lever
of inner circuit. Move the lever into upper
position. The implement must be low-
ered to ground when stopping the tractor
with attached implement (the implement
must not be left in lifted position).
To Next Page
Loading...
