214
SCHEDULED TECHNICAL MAINTENANCE
TRACTOR INSPECTION AND MAINTENANCE
After accomplishing every…...... Oh
Inspection and maintenance operations
10
70
100
300
600
1 200
1 800
2 400
3 000
3 600
4 200
4 800
5 400
6 000
Inspection of the clutch hydraulic control for tightness and proper operation X Every 10 Oh
TRANSMISSIONS
Replacement of the transmission oil full-flow fiter paper cartridge X X Every 300 Oh
Cleaning of the transmission oil suction filter magnetic and strainer cartridge
∗
X X Every 300 Oh
Inspection of the amount of oil in the gearbox
∗
X X Every 300 Oh
3
Exchange of oil in the gearbox XXX
Inspection of the amount of oil in the front P.T.O. shaft transmission gearbox X Every 300 Oh
3
Exchange of oil in the front P.T.O shaft transmission gearbos
∗
XXXXX
Greasing of the front P.T.O. shaft cross-pin cardan joint X Every 100 Oh
AXLES AND STEERING
3
Exchange of oil in the reducers and in the front driving axle housing
∗
XXXXX
Inspection of the amount of oil in the reducers and in the front driving axle housing X Every 300 Oh
Exchange of oil and replacement of the hydrostatic steering filtering cartridge
∗
XXXXX
4
Replacement of hoses of the hydrostatic steering X X
Greasing of the front axle console central pin Every 50 Oh
Greasing of the steering ball stud XXXXXXXXXX
3
Greasing of the reducer bearings XXX
3
Greasing of the propeller shaft grooves and cross-head pins X X X
Inspection of the front wheel bearing play X XXXXXXXXXX
Inspection of the front wheel toe-in X XXXXXXXXXX
Inspection of the wheel and steering tie rod nuts and bolts for tightening
∗
Every 300 Oh
To Next Page
Loading...
