215
SCHEDULED TECHNICAL MAINTENANCE
TRACTOR INSPECTION AND MAINTENANCE
After accomplishing every … Op
Inspection and maintenance operations
10
70
100
300
600
1 200
1 800
2 400
3 000
3 600
4 200
4 800
5 400
6 000
HYDRAULIC SYSTEM
Greasing of the additional hydraulic cylinder pins X Every 300 Oh
Greasing of the threads of the L.H. and R.H lifting tie rods with CBM grease X Every 300 Oh
Greasing of the front three-point hitch XXXXXXXXXX
Inspection of the front three-point hitch outer hydraulic circuit joints for tightness XXXXXXXXXX
Inspection of the individual hydraulic systems for tightness and operation X X Every 300 Oh
BRAKE SYSTEMS
Inspection of the amount of braking liquid and the tightness of hydraulic brakes X Every 10 Oh
Inspection of the pneumatic brakes for tightness and trailer brake efficiency X Every 10 Oh
Inspection of the foot and parking brakes for proper operation and setting-up XXXXXXXXXX
Setting-up of the pneumatic brake X X X X X X
Setting-up of the hydraulic brake system components X X
Discharge of condensate from the air storage tank through the drain valve XXXXXXXXXX
Greasing of the sliding surfaces of all the parts of pneumatic instruments X X
5
Replacement of rubber components in the brake system X X
6
Revision of the air storage tank XX
ELECTRICAL SYSTEM
Inspection of charging process for proper operation X Every 10 Oh
7
Inspection of the electrical equipment and accessories for proper conditions and
operation X X Every 300 Oh
Inspection of the charging voltage XX
8
Inspection of the electrolyte for level in the storage battery X X Every 200 Oh
To Next Page
Loading...
