216
SCHEDULED TECHNICAL MAINTENANCE
TRACTOR INSPECTION AND MAINTENANCE
After asccomplishing every … Oh
Inspection and maintenance operations
10
70
100
300
600
1 200
1 800
2 400
3 000
3 600
4 200
4 800
5 400
6 000
8 Clearing the battery terminals and theirconservation by vaseline X Every 300 Oh
Inspection of the starter, its bearings, carbon brushes, and brush holders X X
Inspection of the alternator, its bearings, rectifiers, collectors X X
3 Lubrication of the lever drive bearings of the front and rear wipers X X X X X
SAFETY CAB AND TRACTOR ACCESSORIES
Cleaning and lubrication of the tilting steering wheel arresting mechanism XXXXXXXXXX
Inspection of the driver’s seat operation, greasing of movable parts X Every 300 Oh
9 Inspection of the seat hydraulic damper for tightness X X
Lubrication of the hinges of doors, rear window, pins, and door locks XXXXXXXXXX
Lubrication of the automatic coupling mouth for trailers X Every 300 Oh
Lubrication of the hitch for single-axle trailer XXXXXXXXXX
Inspection and contingent cleaning of the cab ventilation filters X Every 10 Oh
Inspection of the suspending and attaching devices including the trailer X Every 10 Oh
Note:
∗ After the first putting of the tractor into operation or after the tractor general repair
1 - Depending on the dustiness and pollution of the air sucked (straw and the like) every 50 to 200 Oh
2 - In the case of operation with the machines attached to the front part clean daily or – depending on the contamination even by shorter in-
tervals
3 - Maximum time period – two years
4 - Replace after 4 years from the date of hose manufacture at the lates. The new hoses may not be older than 2 years since the data of
their manufacture shown at their surfaces.
5 - Maximum period of time 5 years from the date of tractor manufacture
6 - Maximum period of time 5 years from the data of the air tanks manufacture or after an accident
7 - Involves inspection of the front asymmetric headlights setting-up and the setting of plays on the brake light switches (max. clearance
between between the switch and the stop of pedals must be 0,5 to 1,0 mm)
8 - In the summer months, every 100 Oh
9 - In case of liquid leaks, remove the faulty sealings of piston rods, rinse the damper with gasoline, and fill it with 70 cm
3
of buffer oil.
To Next Page
Loading...
