54
ELECTRONIC ENGINE GOVERNOR
RPM4 RPM5 RPM6
INDICATOR LAMP H/O
Indicator lamp H/O indicates switching on
or off the function of keypad MEM. Indi-
cator lamp indicates entering, recalling
and resetting the engine speed in me-
mory of system and moreover it indi-
cates limiting the range of engine speed
increase or decrease.
FUNCTION OF ELECTRONIC GOVER-
NOR
1. Setting the temporary memory
2. Resetting and deleting the temporary
memory
3. Setting the permanent memory
4. Permanent memory recall - H/O lamp
is off
5. Permanent memory recall - H/O lamp
is on
6. Memory reset - return to pedal control
Engine speed, determined for memori-
zing to memory system, can be set either
by throttle control or by foot throttle con-
trol (throttle pedal). Enter, recall and re-
set of memory is possible on the key-
board of hand throttle control.
SETTING THE TEMPORARY MEMORY
1. Indicator lamp H/O must be off.
2. Set the desired engine speed by
hand (keypad MIN or MAX) or foot
throttle control, for example 1600
RPM.
3. Press the keypad MEM; indicator
lamp H/O turns on.
4. Set engine speed 1600 RPM is
memorized.
Since this setting, it is not necessary to
set the engine speed anymore. You can
loose the foot throttle pedal. Engine
speed is maintained in the constant level
(for example 1600 RPM) temporarily
memorized, independently upon tractor
load.
To Next Page
Loading...
