59
ELECTRONIC ENGINE GOVERNOR
RPM16
4. RESET OF TEMPORARY MEMORY
AND RECALL OF ENTRY AND EXIT
SPEED MEMORY
1. Increase engine speed by foot throt-
tle control to avoid sudden dropping
of speed.
2. Press the keypad MEM. Indicator
lamp H/O turns off. Temporary me-
mory is switched off and entered
value is definitively lost.
3. Press and keep (longer than 0,5
sec.) the keypad MAX. You will recall
the value entered in permanent me-
mory by this way. Now the engine
works in regime of entry and exit
speed.
5. RESET OF PERMANENT MEMORY,
SETTING THE OPERATING SPEED
AND ITS TEMPORARY MEMORISING
1. Press the keypad MEM. Indicator
lamp H/O turns off. Permanent me-
mory is switched off.
2. Again set the operating engine speed
by foot throttle control (foot throttle
pedal).
3. Press the keypad MEM. Indicator
lamp H/O turns on. The speed is now
entered into temporary memory.
6. TILLAGE WITH OPERATING SPEED
TEMPORARILY MEMORISED
Activities that are mentioned in point 6
are equal to point 3.
To Next Page
Loading...
